Mohawk Nation of Grand RiverMohawk UniversityStart learning

Courses · MAP 102 Reading the land record: surveys, parcels and map data · Lesson 3 of 4

Placing a parcel on a map

Lecture 3 of 4 · about 7 minutes

Before you begin, ask yourself. The lecture answers these questions, and you will meet them again at the end.

  1. In GeoJSON, which comes first?
  2. Why state the datum?
  3. What should accompany any line you draw on a map?

This lesson is practical. By the end you will have put one parcel on a map from freely available data and said how accurate your placing is. You need a computer or a telephone and nothing else.

Begin with coordinates. Any point on the earth can be named by two numbers. Latitude is the angle north or south of the equator. Longitude is the angle east or west of the meridian through Greenwich. The Mohawk Chapel at Brantford is at about 43.12 degrees north and 80.24 degrees west. Write them as decimals, and remember that west and south are negative: 43.12, −80.24.

Coordinates mean something only against a model of the earth’s shape, called a datum. Two are in use here and they differ by a metre or two: the North American Datum of 1983, which Canadian surveys use, and the World Geodetic System of 1984, which satellites and web maps use. Older maps used a datum of 1927 that can differ by tens of metres or more. Always say which datum your numbers are in.

A flat map needs a projection, a rule for flattening the curved earth. Every projection distorts something. Web maps use one that keeps shapes and badly exaggerates areas far from the equator. Surveyors here use a grid called UTM, in metres, which is accurate over a zone a few hundred kilometres wide. For measuring a distance or an area, use the grid and never a web map. The Nation’s Surveyor General takes corners in UTM on the 1983 datum, in the land’s zone, or in latitude and longitude.

Now the data. Canada and Ontario publish, free and under open licences, the boundaries of townships, lots and concessions, roads, rivers and much else. The parcel fabric itself is not free in Ontario, but lot and concession lines are, and with the plan you learned to read in the first lesson a parcel can be placed within its lot.

The picture sets out the exercise in four steps. Read it from left to right.
Find the lotFrom the parcel’sdescriptionGet its cornersFrom open townshipdataMark the parcelBy the plan’sbearings anddistancesState theaccuracySources; how farwrong

Pause. Look away from the page and say in your own words what “Latitude and longitude” means. Then read on.

The common format for sharing map data is GeoJSON, a plain text file that lists shapes by their coordinates. Its rule on coordinates is printed below, and it holds a trap: longitude comes first, then latitude. A parcel drawn in the Indian Ocean has usually had the two the wrong way round.

Do the exercise in four steps. Find the lot and concession from the parcel’s description. Find that lot in the open data and note its corners. Using the plan’s bearings and distances, mark the parcel’s corners within the lot. Save them as a shape, and open it in any free mapping program to check that it lies where you expect.

Then state the accuracy, and be honest. Say where each corner’s position came from: read from a plan, taken from open data, or estimated. Say how far wrong it could be. “Placed from township data and a 1962 plan; corners within about ten metres” is a proper statement. A line on a map with no such statement invites a trust it has not earned.

The Nation’s map of the Tract is made in the same way, at a larger size: from sources that are named, with the accuracy of each part stated. What you have just done to one parcel is what MAP 201 describes for the whole, and the next lesson shows how the Nation states it.

The source

The coordinate reference system for all GeoJSON coordinates is a geographic coordinate reference system, using the World Geodetic System 1984 (WGS 84) datum, with longitude and latitude units of decimal degrees.
The GeoJSON Format (RFC 7946), section 4 · Internet Engineering Task Force, August 2016.

Key terms

Latitude and longitude
The two angles that name a point on the earth.
Datum
The model of the earth’s shape against which coordinates are measured.
Projection
A rule for showing the curved earth on a flat map; every one distorts something.
GeoJSON
A plain text format for map shapes; longitude is written first.

Check yourself

1.In GeoJSON, which comes first?
2.Why state the datum?
3.What should accompany any line you draw on a map?

Send to your teacher

Opens your own email with your answers written in. Nothing is sent to or kept by the University.

Summary

Go back to the questions at the top. You should now be able to answer each in a sentence, and to explain these terms: Latitude and longitude, Datum, Projection, GeoJSON.