Mohawk Nation of Grand RiverMohawk UniversityStart learning

Courses · MAP 201 The matrix survey · Lesson 2 of 4

The outermost line

Lecture 2 of 4 · about 6 minutes

Before you begin, ask yourself. The lecture answers these questions, and you will meet them again at the end.

  1. What is the outermost boundary?
  2. A line that will not close within tolerance is…
  3. Why settle the outermost line first?

Once the determinations are laid side by side, the Nation settles an outermost boundary: the line no source places further out.

The line is then closed: each leg is measured and the figure must return to its starting point within the survey class’s tolerance. A line that will not close is not settled.

Why the outermost line? Because of what the matrix is for. The Nation is assessing how far the Proclamation’s grant may reach, so that nothing within the grant is left out of account. The line that no source places further out is the limit of the question: beyond it, no one claims the Tract runs.

Inside that line, each source’s own line is kept, and the land between two lines is land about which sources differ. That is useful knowledge. It tells the Nation where its position is supported by every source and where by one only.

Closing a line. Read left to right: a traverse is run, the gap is measured, and the gap is judged against the tolerance.
TraverseLegs of bearing anddistance, back tothe startMisclosureThe gap between theend and the startPrecisionGap ÷ length: say 1in 10,000ToleranceWithin the class’slimit, or measuredagain

Pause. Look away from the page and say in your own words what “Outermost boundary” means. Then read on.

A line is then tested by closing it. A surveyor runs a traverse: from a starting point, a series of legs, each with a bearing and a distance, returning to the start. If the measurements were perfect the last leg would end exactly where the first began. It never does; the gap is the misclosure.

The misclosure is compared with the length of the whole traverse. A gap of one metre in a traverse of ten kilometres is a relative precision of one in ten thousand. Each class of survey has a tolerance, and a traverse that misses it is measured again.

The Register’s Surveyor General keeps the survey classes and their tolerances, in versions, so that a line settled this year can be checked next year against the rule that applied when it was made.

A worked figure makes the idea plain. Suppose a traverse round a block of the Tract has eight legs and a total length of 24 kilometres, and the last leg ends 1.6 metres from the starting point. The relative precision is 1.6 in 24,000, or one in 15,000. If the class of survey allows one in 10,000, the traverse passes. If the gap had been 4 metres, one in 6,000, it would fail, and the surveyor would look first for a single bad leg, since one mistake is far more common than many small ones. Closure does not prove the line is in the right place; it proves the measurements agree with one another. Whether the line is the right one is the matrix’s business.

Key terms

Outermost boundary
The line no determination places further out.
Closing distance
How far a traverse misses its starting point.
Tolerance
The miss a survey class allows.

Check yourself

1.What is the outermost boundary?
2.A line that will not close within tolerance is…
3.Why settle the outermost line first?

Send to your teacher

Opens your own email with your answers written in. Nothing is sent to or kept by the University.

Summary

Go back to the questions at the top. You should now be able to answer each in a sentence, and to explain these terms: Outermost boundary, Closing distance, Tolerance.